Our Sleeve Tools are 100% Made in the USA! Machined right here in Northeast Ohio!
The 7.3L Power Stroke injectors sit in a brass sleeve that separates the injector, and fuel, from the engine's coolant. These brass sleeves weaken and fatigue from age and tend to split and fail. A common symptom is finding fuel in your cooling system. This happens because the fuel system typically operates at around 60 psi of pressure, whereas the coolant system operates at a much lower pressure so the fuel gets pumped into the coolant when the sleeve fails and cracks.
We offer these custom made tools to simplify the changing of the sleeves. By design, the tools are shorter than an injector so you can change the sleeves with the heads on the motor and the motor still in the truck since there is no slide hammer required like with some other sleeve tools. Our tools are Black Oxide and Hard Coat Anodized for long life. You can replace your sleeves as preventative maintenance now, or replace them later once you detect signs of failure.
Here are some basic instructions on how to use our tools: Sleeve Tool Instructions.
Write the First Review!
You must login to post a review.
California Residents: Prop 65 Warning
WARNING: Cancer and Reproductive Harm