Additional Images

98.5-03 7.3L CNC Fab Fuel Bowl Relocation Retrofit Block - 42202X

42202X
CNC FABRICATION early 99-03 7.3L Powerstroke Fuel Bowl Relocation Manifold. This retro-fit manifold is a direct swap for the fuel bowl when using our Fuel Bowl Retain 4 line feed fuel line kit. COMES WITH FITTINGS
NOTE: This product has the following shipping restriction(s):
  • Not available for sale in the state of California.
Pricing: $124.95

Customize Your Item

- Add Filter Relocation Kit -
 * required
- Select Fuel Block Color -
 * required
Qty:
NOTE: This product has the following shipping restriction(s):
  • Not available for sale in the state of California.
Free Shipping!

Description

THIS IS NOT A COMPLETE BOWL RELOCATION KIT (Unless you select the add-on kit). MUST ALREADY HAVE ONE OF THE 4 LINE FEED FUEL BOWL RETAIN KITS TO USE.

Typically, most aftermarket filters are mounted on the frame. For stock to mild horsepower applications, we recommend using the CNC Fabrication fuel bowl relocation kit that utilizes your factory fuel pump.  For mild to higher horsepower applications, we recommend the AIRDOG II 5G PUMP or an AEM Performance fuel pump for a fairly easy complete fuel tank to engine fuel system.  

**Looking to relocate your fuel bowl? Select the Fuel Bowl Relocation Kit from the Drop Down Menu**

This is an affordable option over a FASS or AirDog fuel pump setup that will retain your factory fuel pump.

TRUCK YEARS: 1999-03 ENGINE TYPE: 7.3L

A direct swap for customers who have previously purchased our popular Fuel Bowl Retain Kit, this manifold block cleans up the engine valley area, allowing better access to the high pressure oil pump and lines.

Kit comes with fuel rated supply Pushlok style fittings, so all you need to do is supply your fuel rated hose from your pump to the block.

EASY INSTALLATION: Very little is needed to do with this retro-fit manifold.  The block is about a 15-30 minute swap in the engine valley.

  1. Simply loosen/remove all of the fuel line retaining nuts and unplug the bowl heater (if applicable)
  2. Disconnect the bowl drain valve and then remove the 2 bolts holding the bowl to the HPOP reservoir
  3. Next, remove the fittings that came with the CNC FABRICATION 4-line feed kit that was installed on the bowl, and install them into the new manifold
  4. Using the newly supplied bolt to hold the manifold, reattach the fuel lines
  5. Last, add a regulator, pre/post pump filters and a line up to the manifold

NOTE:  The threads for the inlet are -08 SAE o-ring boss, which is a standard thread type for hydraulics and fuel fittings

offical product

Details

Shipping Information

  • Item Requires Shipping
  • 2.0 lbs.
  • W4.0000” x H4.0000” x L4.0000”
  • Free Shipping!

Customer Reviews

Comment Total Reviews (0)

Write the First Review!

You must login to post a review.